ASI Products

Aquatic Systems - Products

Temperature Series - LC300

Features

Temperature Series - LC300

Better than 1°C Accuracy
Frequent refresh rate in both Celsius and Fahrenheit.
Extended battery lifetime
Reliable wireless telemetry system that is insensitive to noise.
Communication protocol optimized to differentiate the incoming input signal from interference.

Aquatic Systems is working with Advantage Leisure Products Inc. in integrating chemical and temperature control in a new product line. This DX300 series product line is expected by December 2006.

Installation Instructions and Product Use

The LC300 product is easy to install and operate.

Home (receiver) unit:
1) Install 2 screws into the wall with a distance of 3" apart. Leave the heads of the screws out from the wall by about 1/8".
2) Install the unit to the wall by the slot in the back-plate. (be sure to be near a 115V AC outlet.)
3) Install the AC-DC power adapter and plug into the jack on the receiver.

Spa (transmitter) unit:
1) Unscrew the backplate from the spa unit and install 4 AA batteries into the appropriate battery pack. (Follow battery polarity.)
2) Reinstall the plate.
3) Wet the suction cups with fresh water and stick to any wall of the tub. (The base of the unit must be 1" under the water.)
4) Turn on the transmitter and observe the temperature on the display of the home unit.

Notes: Avoid installing the system where there are large metal objects and large concrete structures in between the spa and home unit.
Do not install either unit near AC power cables or transformers. For best results ensure a direct line of sight between the two units. For maximum product lifetime, use AA alkaline batteries of the same make.

Specifications

Minimum 1.0°C accuracy
Temperature range from 4°C to 65°C.
Active display in Celsius and Degrees
Minimum refresh rate: 2 samples per minute
Reliable and insensitive to noise.
Long battery lifetime under continuous use (Greater than 4 months)
Transmitter (Spa) unit runs on batteries
Receiver (Home) unit runs on wall AC-DC adapter.

System Requirements

A spa or body of water required (not supplied with the LC300)

Transmitter:
4 x AA (or AAA) batteries (1.5 V alkaline only. Use AA/AAA batteries of the same make.)

Receiver:
9V AC-DC wall adapter or 9V battery